Air Pressure

VE6.4.2.7
Air Pressure
Air Pressure

This product is classified as a dangerous good and is not available for online purchase.

For ordering the dangerous good or other information please contact our customer service center.
This experiment/set up contains dangerous goods.
These are not available for online purchase.
You may order the experiment/set up without the dangerous goods.


For ordering the dangerous good or other information please contact our customer service center.
Email: webshopuk@ld-didactic.de
Telephone:+49 (0) 22 33 / 604 – 319
Go to contact form

˟

Request an offer

Thank you for your inquiry. We will get back to you as soon as possible.

˟

Description

System

The Pressure Process Control Training System is a single loop pneumatic control system. It enables the study of the principles of both pressure regulation of a process and the control of flow in a pressurised system. The system comprises a low pressure air circuit supported on a bench-mounted panel, making it suitable for individual student work or for group demonstration. The trainer requires a compressed air supply at a recommended input pressure of 40 psi (not supplied) An input filter/drier is used to clean the supplied air. Separately regulated branches provide air for the process and for valve control. The process branch comprises a regulator, a variable area flow meter, a pneumatically operated control valve, an orifice block with changeable orifice plates and both differential and point of measure pressure sensors. The process air flow can be discharged to atmosphere via adjustable diffused outlets. An air receiver tank can be switched in and out of the circuit. The valve control branch comprises a regulator and an electrically operated current to pressure input converter. This is used to regulate the pneumatic control valve in the process line. The input converter operates from a 4-20 mA signal. Signal conditioning for the sensors is provided by pressure transmitters. The Differential Pressure Transmitter gives a linear differential pressure sensor output. The system is fully equipped with pressure gauges to indicate the pressures around the system.

Functions

  • Safe, low pressure operation
  • Fully gauged for pressure & flow rate
  • Differential & Gauge pressure sensors
  • Currect controlled (4-20 mA) pneumatically operated control valve
  • Standard industrial components
  • Self-sealing outlets for the manometer
  • Safety valves fitted as standard
  • Air used as the process fluid

Topics

  • Pressure safety, familiarisation & calibration
  • I/P converter & pneumatic control valve operation
  • Controller familiarisation & calibration
  • Automatic control systems
  • Serial communication
  • Pressure sensor
  • Transmitter & I/P converter - linearity & hysteresis
  • Pneumatic control valve
  • Characteristics at different pressure ranges
  • System response & air receiver
  • Principles of proportioning valve & proportional process control
  • Study of P, PI and PID control of pressure
  • Calibration of the differential pressure sensor & transmitter
  • Flow control in the process rig

Components of equipment sets

1 38-004 Pressure Process Control Trainer FB
1 38-003_004-SW ESPIAL PROCON Course Software FB
1 93-420 ESPIAL Software Package FB
1 38-820-230 Air Compressor FB
1 additionally required: 1 PC with Windows 7 / 8.1 / 10 (x86 or x64)
Experiments are operated and evaluated with espial.
The equipment can require additional software modules.
Print page

Contact Us

Customer Centre:
Technical Service-Hotline:
Local contact - Feedback Instruments Limited:
Click here for our Contact Form or Postal address.

Contact Us